Hello everyone,
My doubt is that I have connected a PL2303 USB to TTL. I have connected the 3 pins to GND, GPIO14 and GPIO15. But i am not getting a UART out through that into my console. I am using Raspberry Pi 5 device. Console is showing nothing. In the config.txt I have entered enable_uart=1. My current situation is showing u-boot logo at the top right. Or should i buy the 3-pin JST to connect to the debug uart between the micro hdmi's. I am a newbie here.
Thanks in advance
My doubt is that I have connected a PL2303 USB to TTL. I have connected the 3 pins to GND, GPIO14 and GPIO15. But i am not getting a UART out through that into my console. I am using Raspberry Pi 5 device. Console is showing nothing. In the config.txt I have entered enable_uart=1. My current situation is showing u-boot logo at the top right. Or should i buy the 3-pin JST to connect to the debug uart between the micro hdmi's. I am a newbie here.
Thanks in advance
Statistics: Posted by klein — Fri Jan 02, 2026 2:00 am