Okay I'm now trying with over_voltage=2, I'll keep you updated. I didn't try before because the core voltage was already between 1.28V and 1.32V, now with over_voltage=2 it reaches 1.3563V.Some Pi02 can be a little on edge over system voltage.
Adding "over_voltage=2" to /boot/firmware/config.txt can sometimes help as it just turns the wick up a little.
Each time at the beginning of the crash, I have these 2 kernel logs
Also, I do have arm_boost=1 in my config.txt. Here is the complete config.txt I have right now.
Code:
# For more options and information see# http://rptl.io/configtxt# Some settings may impact device functionality. See link above for details# Uncomment some or all of these to enable the optional hardware interfaces#dtparam=i2c_arm=ondtparam=i2s=ondtoverlay=googlevoicehat-soundcard#dtparam=spi=on# Enable audio (loads snd_bcm2835)dtparam=audio=on# Additional overlays and parameters are documented# /boot/firmware/overlays/README# Automatically load overlays for detected camerascamera_auto_detect=1# Automatically load overlays for detected DSI displaysdisplay_auto_detect=1# Automatically load initramfs files, if foundauto_initramfs=1# Enable DRM VC4 V3D driverdtoverlay=vc4-kms-v3dmax_framebuffers=2# Don't have the firmware create an initial video= setting in cmdline.txt.# Use the kernel's default instead.disable_fw_kms_setup=1# Run in 64-bit modearm_64bit=1# Disable compensation for displays with overscandisable_overscan=1# Run as fast as firmware / board allowsarm_boost=1[cm4]# Enable host mode on the 2711 built-in XHCI USB controller.# This line should be removed if the legacy DWC2 controller is required# (e.g. for USB device mode) or if USB support is not required.otg_mode=1[cm5]dtoverlay=dwc2,dr_mode=host[all]enable_uart=1dtoverlay=ramoops,mem_size=0x20000,console-size=0x10000over_voltage=2Statistics: Posted by pierre79 — Mon Sep 22, 2025 8:26 am