Hello Everyone,
I am new to Raspberry Pi, I tried to make VNC work, but it is not working properly, the resolution is only 720p.
I watched several posts and videos, but I couldn't solve my problem.
This is how it is displayed on the VNC Client.The following are the configurations.then also I updated the raspi config as 1920x1800 but couldn't attach the screenshot.
The following is the content of the config.txt file present in the boot/firmware/ folder.Another important point is that this all happens when there is no HDMI and monitor connected to the RPi.
When the HDMI Cable and Monitor are connected, I can see perfect resolution on both (monitor and VNC client), as soon as the HDMI cable is removed, the resolution changes like this.
Any suggestion, on what mistake I am making?
Thanks and Regards
I am new to Raspberry Pi, I tried to make VNC work, but it is not working properly, the resolution is only 720p.
I watched several posts and videos, but I couldn't solve my problem.
This is how it is displayed on the VNC Client.
The following is the content of the config.txt file present in the boot/firmware/ folder.
Code:
# For more options and information see# http://rptl.io/configtxt# Some settings may impact device functionality. See link above for details# Uncomment some or all of these to enable the optional hardware interfacesdtparam=i2c_arm=off#dtparam=i2s=ondtparam=spi=off# Enable audio (loads snd_bcm2835)dtparam=audio=on# Additional overlays and parameters are documented# /boot/firmware/overlays/README# Automatically load overlays for detected camerascamera_auto_detect=1# Automatically load overlays for detected DSI displaysdisplay_auto_detect=1# Automatically load initramfs files, if foundauto_initramfs=1# Enable DRM VC4 V3D driverdtoverlay=vc4-kms-v3dmax_framebuffers=2# Don't have the firmware create an initial video= setting in cmdline.txt.# Use the kernel's default instead.disable_fw_kms_setup=1# Run in 64-bit modearm_64bit=1# Disable compensation for displays with overscandisable_overscan=1# Run as fast as firmware / board allowsarm_boost=1[cm4]# Enable host mode on the 2711 built-in XHCI USB controller.# This line should be removed if the legacy DWC2 controller is required# (e.g. for USB device mode) or if USB support is not required.otg_mode=1[all]#dtoverlay=w1-gpioWhen the HDMI Cable and Monitor are connected, I can see perfect resolution on both (monitor and VNC client), as soon as the HDMI cable is removed, the resolution changes like this.
Any suggestion, on what mistake I am making?
Thanks and Regards
Statistics: Posted by xpress_embedo — Wed Mar 06, 2024 7:36 pm