shouldn't you use..
when I connect the camera to with rib cable the led on the camera goes on so it is not the issue.
The camera is connected to the port 0 of the pi
After accessing the config with "sudo nano /boot/firmware/config.txt" i have edited the camera_auto_detect = 0 and added at the bottom "dtoverlay=imx219"
i have also tested with the value to 1 but still
when i run "ls /dev/video*" the video0 does not list
no matter what i still get "no cameras available"
..
Code:
dtoverlay=imx219,cam0Why did you disable camera auto detect?
Statistics: Posted by aBUGSworstnightmare — Mon May 06, 2024 8:56 am